Hardware Diagnostics HW Diagnostics Program Main Menu 125ā 06. SCSI HDD TEST checks the HDD functions connected to the SCSI-Bus throughASPI driver software. Before starting the test, select the following parameters.- 01. Sequential address read subtest is a sequential reading of all the blocks on theHDD starting at block 0.- 02. Connection subtest reads the logical sector at the end of the HDD and thenrecognizes if the drive is connected or not.SCSI HDD TEST (HDD) Error LogParameter MeaningHOST ID NUMBER Sets the target host adapter number. When youchoose "ALL", the subtest tests all disks connectedto the server, and the next options, SCSI ID andCHANNEL number will be ignored.SCSI ID NUMBER Sets the SCSI ID to test. You can specify just one IDto test except ID:7.CHANNEL NUMBER If the server has multiple SCSI channels, this optionsets the channel number to test.NOTE: The 01. SEQUENTIAL ADDRESS READ tests all area of the hard diskdrive. Depending on the capacity of the installed hard disk drives, the test may takea few hours.If you do not know where the hard disk drives are connected (host ID, SCSI ID andchannel number of the SCSI controller), you can find them 01. INQUIRY of 09.SCSI TEST.Status Error name Meaning01 CHECK CONDITION OR BADCOMANDBad command error03 DRIVE SELECTION FAILED Drive selection error04 TARGET DRIVE BUSY Target drive is busy05 SCSI BUS TIME OUT Time out error of SCSI bus09 DMA BOUNDARY ERROR DMA BOUNDARY occurred0D COMMAND TERMINATED Command terminated0E QUEUE FULL Command queue is full80 NO SENSE Sense data is invalid81 RECOVERD ERROR Execution of the command hascorrectly finished because ofrecovery treatment.82 NOT READY Condition does not satisfy for thecommand execution
