Toshiba H7 Operation Manuals

Also see for Adjustable Speed Drive H7 Series: Applications Workbook Specification

Contents

H7 ASD Operation Manual 167Stop PatternNo path available (Direct Access Only)While operating using the LED Keypad Option the Stop Pattern parameterdetermines the method used to stop the motor when the stop command is issuedvia a Stop command from the LED Keypad.The Decel Stop setting enables the Dynamic Braking system that is setup atF304 or the DC Injection Braking system that is setup at F250, F251, andF252.The Coast Stop setting allows the motor to stop at the rate allowed by theinertia of the load.Settings:Decel StopCoast StopNote:The Stop Pattern setting has no effect on the Emergency Off settings ofF603.If using the LCD EOI, press ESC from the Frequency Commandscreen to access this parameter.Direct Access Number — F721Parameter Type — Selection ListFactory Default — Decel StopChangeable During Run — YesTorque Limit GroupNo path available (Direct Access Only)While operating using the LED Keypad Option this parameter is used to select1 of 4 preset positive torque limits to apply to the active motor. The settings ofprofiles 1 – 4 may be setup at F441, F444, F446, and F448, respectively.Note: If using the LCD EOI, press ESC from the Frequency Command screento access this parameter.Direct Access Number — F723Parameter Type — Selection ListFactory Default — 1Changeable During Run — YesFeedback in Panel ModeNo path available (Direct Access Only)While operating using the LED Keypad Option this parameter Enables/Disables PID feedback control.Note: If using the LCD EOI, press ESC from the Frequency Command screento access this parameter.Direct Access Number — F724Parameter Type — Selection ListFactory Default — EnabledChangeable During Run — YesLED Option Override Multiplication GainProgram ⇒ Feedback Parameters ⇒ Override ControlIf operating using the LED Keypad Option this parameter provides a value tobe used in the event that Setting is selected for the Frequency OverrideMultiplying Input (F661).Direct Access Number — F729Parameter Type — NumericalFactory Default — 0.00Changeable During Run — YesMinimum — -100.00Maximum — 100.00F721 F729www . ElectricalPartManuals . com