12-712Other Settings and OperationsFrom the preceding pageAdjusting the camera position (after the camera is replaced or dislocated)Adjust these parameters using the following procedure.Enter the through display modeAdjust each parameter (adjust the camera and lens).Enter the freeze display mode.10. Store the image after replacing the camera by pressing the SET key in item 8 IMGAFTR CAM CHNG on the [ADJ. CAM POSITION] menu.StartAdjusting the camera position/directionAdjusting the lens aperture *White area in the differential imageExists.RoughadjustmentDetailedadjustment8. Press the SET key on item 6DISP DEG OF MATCH9. Compare the values before andafter the camera is replaced,which are shown in item 9DISPLAY LABELSNoneAdjusting the camera position/directionMismatchMismatchMismatchAdjustment of size(comparison of fillet diameters)MatchMatchMatchAdjusting the camera position/direction *Adjustment of position(comparison of the centers of gravity)Adjusting the lens aperture *Adjustment of brightness(comparison of average light level)End81096DISP DEG OF MATCH (SET KEY)7INTIAL CAM IMG REG. LABL108IMG AFTR CAM CHNG (SET KEY)9DISPLAY LABELS LABL00 BER.CHG AFT.CHGGRAVITY X 310. 292.0GRAVITY Y 220.0 219.0FILLET X 040 040FILLET Y 040 032AV-L.LVL 100 100.00UPPER MENU[ADJ. CAM POSITION]
