9-29Shared settings91423[TYPE01-MEAS0]1SELECT MEAS. TYPE NO MEAS-POSITION-DEVIATE2COPY : EXEC TYPE00 CMR1POS-DEVIATION3INITIALIZATION EXEC4MEAS. PROG. COND (TO NEXT SUB-MENU)5EVALUATION COND (TO NEXT SUB-MENU)6NUMERIC CALC COND (TO NEXT SUB-MENU)7OUTPUT CONDITIONS (TO NEXT SUB-MENU)8UPPER MENUOn the MAIN OPS MENU, move the cursor to SET-SCRN item, and press the SET key.- On the [SYSTEM SETUP] menu, move the cursor to 2 OBJECT TYPE COND(conditions of object type) and pess the SET key.- On the [OBJECT TYPE COND] (conditions for object type) menu, set item 1OBJECT TYPE NO. (object type number) to 01 and select item 4 MEAS.0,CAMERA1.- When processing item 2 COPY, by itself, the IV-S20 will not copy to the flash memory.To save the copied settings in flash memory go to item 9 SAVE IN FLASH MEM, or item 0OPERATIONS, which are both found on the [SYSTEM SETUP] menu.Note(2) Copying between measurement programsCopying a specific measuring program's settings from on object type number to another.[The procedure for copying measurement program 0]- Example: Copying the (object type number 00, measurement 0, program settings: forpositional deviation measurements) into the settings for (object type number 01,measurement 0, program setting no).The settings for the same measuringprogram in a different object typenumber. (The data is used to simplifysetting the target object's parameters)The target of the copyThe specific measuring programsettings stored in a particularobject type number. (The data iscopied from flash memory)The source of the copy1.Select item 2 COPY using the up and down keys and press SET key.2.Enter the object type number (00 to 15) for the source copy using the up and down keys. Thename of the measurement program for this object type number will also be displayed. Whenthe number has been entered, press the SET key.3.Once the measurement program has been copied, the underlined entry at item 1 SELECTMEAS.TYPE (select measurement) will now be MEAS-POSITION-DEVIATE (positionaldeviation measurement) whereas NO was previously underlined.4.Move the cursor to item 8 UPPER MENU, and press SET key twice.- This will return you to the [OBJECT TYPE COND] menu.
