7-27Setting and Operating Outlines7-2 Screen specifications[1] Operation (run) screenSupply power to the IV-S20 main housing, and the MAIN OPS MENU (startup screen) will bedisplayed on the monitor.- Before applying the power, make sure that the power cable, monitor cable, camera cables, andremote key pad have been connected to the IV-S20 main housing.F L C1ALLC2NOLOCK VX.XC1=002.2 OKC2=100.0 OK(TYPE00)AREA1OKMEAS. XXXXXXmsMEAS0 CAM1 POS-DEVIATIONSelect BUSY or READY onthe [I/O CONDITIONS]menu.Object type No. (00 to 15) and the name assigned by the user for each object typeDisplay of the results of the programmable output (auxiliary relay C116)If C116 has not been set, the results of C112 are output. (See page 10·7)FL C1 ALL C2NODisplayOKNG"OK" is displayed when all of the individual evaluation results are acceptable."NG" is displayed if any single evaluation result is unacceptable.(Errormessage)DescriptionOutput monitor statusCamera 1 (C1)/camera 2 (C2) = All/upper/middle/lower/noneImage brightness: H = Original brightness of captured imageL = Brightness reduced to half that in the captured imageImage display mode: F = Freeze mode N = No camera inputLOCK VX.XSystem program version numberRun menu lock ("LOCK" is not displayed while the screen is unlocked.)C1 002.2 OK· This item is displayed when the illuminance monitor MONITOR LIGHT LVL on the[OBJECT TYPE I/O] menu has been set to "YES." (See page. 9·115.)Measurement No. (0 to 3), camera No. (1 or 2) and measurement program nameAverage density during measurement, and judgment (OK/NG)Camera No. (C1 = camera 1, C2 = camera 2)Flashes during communicationsAn error code and the measurement number that caused the error aredisplayed on the upper line. The error message is displayed on the lower line.X0 6: Y0 7: BUSY:MSR-CHNG REG-CHNG PC-MONTR SET-SCRN MANL-TYP-CHGOperation status display: flashing = running, flashing = CCD triggersampling
