Qlogic SANbox 5602 User Manual

Also see for SANbox 5602: Supplementary guide Guidelines Installation Installation guide User guide

Contents

Qlogic SANbox 5602 User Manual Manual pdf 183 page image

A – Command Line InterfaceReset Command59097-00 A A-330 Clears the event log. To save the event log before resetting, refer to the ”SetLog Command” on page A-52.To reset the switch with a power-on self test, refer to the ”Hardreset Command” onpage A-20. To reset the switch without disrupting traffic, refer to the ”HotresetCommand” on page A-23.systemResets the system configuration settings to the factory default values. Refer toTable A-8 for system configuration default values.zoningClears the zoning database and deactivates the active zone set. The zoningconfiguration values (autosave, default visibility) remain unchanged.Notes The following tables specify the various factory default settings:Note: Because this keyword changes network parameters, theworkstation could lose communication with the switch. This keyword does not affect installed license keys.Table A-3. Switch Configuration DefaultsParameter DefaultAdmin State OnlineBroadcast Enabled TrueInbandEnabled TrueFDMIEnabled TrueFDMIEntries 1000Domain ID 1 (0x Hex)Domain ID Lock FalseSymbolic Name SANbox ManagerR_A_TOV 10000E_D_TOV 2000Principal Priority 254Configuration Description Default Config