A – Command Line InterfaceFirmware Install Command59097-00 A A-190Firmware Install CommandDownloads firmware from a remote host to the switch, installs the firmware, thenresets the switch (without a power-on self test) to activate the firmware. Ifpossible, a non-disruptive activation is performed. The command prompts you forthe following: IP address of the remote host An account name and password on the remote host Pathname for the firmware image fileAuthority AdminSyntax firmware installExamples The following is an example of the Firmware Install command:SANbox Manager (admin) #> firmware installWarning: Installing new firmware requires a switch reset.A stable farbic is required to successfully activate the firmware on aswitch without disrupting traffic. Therefore, before continuing withthis action, ensure there are no administrative changes in progressanywhere in the fabric.Continuing with this action will terminate all management sessions,including any Telnet sessions. When the firmware activation is complete,you may log in to the switch again.Do you want to continue? [y/n]: yPress 'q' and the ENTER key to abort this command.User Account : johndoeIP Address : 10.20.33.130Source Filename : 4.2.00.11_mpcAbout to install image. Do you want to continue? [y/n] yConnected to 10.20.33.130 (10.20.33.130).220 localhost.localdomain FTP server (Version wu-2.6.1-18) ready.331 Password required for johndoe.Password: xxxxxxxxx230 User johndoe logged in.bin200 Type set to I.verboseVerbose mode off.This may take several seconds...The switch will now reset.Connection closed by foreign host.
