Qlogic SANbox 5602 User Manual

Also see for SANbox 5602: Supplementary guide Guidelines Installation Installation guide User guide

Contents

Qlogic SANbox 5602 User Manual Manual pdf 159 page image

A – Command Line InterfaceAdmin Command59097-00 A A-90Admin CommandOpens and closes an Admin session. The Admin session provides commandsthat change the fabric and switch configurations. Only one Admin session can beopen on the switch at any time. An inactive Admin session will time out after aperiod of time which can be changed using the Set Setup System command.Refer to the ”Set Setup Command” on page A-57.Authority AdminSyntax adminstart (or begin)end (or stop)cancelKeywords start (or begin)Opens the admin session.end (or stop)Closes the admin session. The Hardreset, Hotreset, Logout, Shutdown, andReset Switch commands will also end an admin session.cancelTerminates an Admin session opened by another user. Use this keyword with carebecause it terminates the Admin session without warning the other user andwithout saving pending changes.Notes Closing a Telnet window during an admin session does not release the session. Inthis case, you must either wait for the admin session to time out, or use the AdminCancel command.Examples The following example shows how to open and close an Admin session:SANbox Manager #> admin startSANbox Manager (admin) #>...SANbox Manager (admin) #> admin endSANbox Manager #>