4 – Managing SwitchesRestoring a Switch59097-00 A 4-290 2. Open the Switch menu in the faceplate display and select Restore to displaythe Restore dialog shown in Figure 4-12. The Restore dialog offers a FullRestore and a Selective Restore tab.Figure 4-12. Restore Dialogs – Full and Selective3. Enter the archive file name or browse for the file. This archive file must beone that was produced by the SANsurfer Switch Manager Archive function.Configuration backup files created with the Config Backup command are notcompatible with the SANsurfer Switch Manager Restore function.4. To restore all configuration settings, click the Full Restore tab, then click theRestore button. To restore selected configuration settings, click theSelective Restore tab and check one or more of the following boxes, thenclick the Restore button: Network Properties: Restores all settings presented in the Networkproperties dialog except the IP address. Refer to ”Network Properties”on page 4-22. IP Address: Restores switch IP address in addition to the othernetwork properties. Switch Properties: Restores all settings presented in the Switchproperties dialog except the domain ID. Refer to ”Switch Properties” onpage 4-17. Domain ID: Restores switch domain ID in addition to the other switchproperties.
