Panasonic WV-NP472 Operating Instructions Manual

Also see for WVNP472 - COLOR CCTV CAMERA: Brochure Reference Reference Specifications

Panasonic WV-NP472 Operating Instructions Manual Manual pdf 33 page image

-33-3. E-Mail Notice Setup• Select ON or OFF for E-mail Notice.ON: Sends an e-mail when an alarm operates.OFF: Does not send.• Enter the e-mail server address.A hostname.domainname can be enteredwhen using the DNS function.• Enter the sender name. The default setting isNW_camera.• Select ON or OFF for Attach Image.ON: Attaches the image data to an e-mail.OFF: Does not attach.• Click the SET & REBOOT button.• Enter a maximum of 4 destination addresses,and click the SET button.• Click the DEL (delete) button after selecting anunwanted destination to cancel it.4. Recording SetupThe image fields are stored before and after thealarm input in the memories of the camera.• Set the image frame numbers for the prerecording (0 – 20) and post recording (1 – 20).• Set the recording rate (fps: frame per second).Rates for Before: 1/10, 1/5, 1/3, 1/2, 1, 2, 3.3, 5Rates for After: 1/10, 1/5, 1/3, 1/2, 1, 2, 3.3, 5,10• Click the SET&REBOOT button.5. Panasonic Protocol Setup• Select ON or OFF.ON: Sends alarm notice mails to the cus-tomized destinations.OFF: Does not send.• Enter the destination port. The port number isexclusively assigned to this function, andany other usage is not allowed.• Enter the retry times from 1 to 25.• Click the SET button.• Enter a maximum of 8 destination IP address-es, and click the SET button.• Click the DEL (delete) button after selecting anunwanted destination to cancel it.6. External Terminal Output SetupThe alarm output is supplied from the terminal onthe rear of the camera.• Select a signal type that the connected deviceaccepts.Pulse: Holds active status during the specifiedtime width.Latch: Holds active status until it is reset man-ually.• Enter pulse width (n x 100 milli-seconds) if youselected Pulse. A number from 1 to 100 isallowed.• Click the SET&REBOOT button.7. Alarm Reset• Click the ALARM RESET button to cancel theactivated alarm.■ FTP Client SetupImage files can be transferred to the FTP server withinthe scheduled time zone.1. Open the FTP Client Setup window.2. Common Setup• Enter the FTP server address.A hostname.domainname can be enteredwhen using the DNS function.• Enter the user name with a maximum of 16characters.• Enter the password with a maximum of 16characters.• Select a transmission mode from Sequential orPassive. Passive is recommended whenSequential does not perform properly.• Complete the schedule 1 and 2, by specifyingthe transmission time zone and the day of aweek.3. None Alarm (FTP) Image Transmission Setup• Select ON or OFF to transmit ordinary imagefiles except during an alarm event.ON: Transmits files when a scheduled timecomes.OFF: Does not transmit, and no schedule isapplied.• Enter a receiver directory.