Panasonic WV-NP472 Operating Instructions Manual

Also see for WVNP472 - COLOR CCTV CAMERA: Brochure Reference Reference Specifications

Panasonic WV-NP472 Operating Instructions Manual Manual pdf 22 page image

-22-To reset to the factory settings (CAMERA RESET)1. Move the cursor to CAMERA RESET. PUSH SW ishighlighted.2. While holding down L and M, hold down Ifor 2 seconds or more. The camera is reset to thefactory settings.NETWORK SETUPSet up network parameters when connecting the10/100BASE jack with a network.Notes:• Access the setup menu from the PC to use theDHCP or DNS server, because these settings arenot included in this window.• Ask your system administrator or ISP (InternetService Provider) about available IP address, sub-net mask, and gateway, prior to setup.• The assigned address should be a global typewhen connecting via the Internet. Ask your ISPwhether it is.1. Move the cursor to NETWORK SETUP in the SETUPmenu window and press I. The NETWORKSETUP menu opens.The factory default settings are as follows.IP ADDRESS: 192.168.0.10NETMASK: 255.255.255.0GATE WAY: 192.168.0.1HTTP Port Number: 802. Move the cursor to the line you wish to edit, andpress I.Parameters become editable.3. Select a digit using J or K.4. Select a number in the digit using L or M.5. Repeat steps 2, 3 and 4 above appropriately untilall parameters are set.6. Move the cursor to END and press I to close thesetup menu and store new settings, or select RETto go back to the SETUP menu.Note: The port number assigned to the camera isexclusive, and any other usage is not allowed.** NETWORK SET UP **IP ADDRESS192.168. 0. 10NETMASK 255.255.255. 0GATEWAY 192.168. 0. 1HTTP PORT NO. 80RET END