Panasonic WV-NP472 Operating Instructions Manual

Also see for WVNP472 - COLOR CCTV CAMERA: Brochure Reference Reference Specifications

Panasonic WV-NP472 Operating Instructions Manual Manual pdf 10 page image

-10-Power-in ConnectionsNotes:• Use only a class-2 power supply suitable to thevoltage and current required by the camera. Seespecifications.• Use a UL listed cable (VW-1, style 1007) to pre-vent fire or electric shock.You can use the formula below to select the powersupply, and power cable. The supplied voltage to thepower-in terminals must be between 10.8V and 16V.10.8V(minimum) ≤ VA – 2RLI ≤ 16V (maximum)VA: Output voltage of power supplyR: Resistance (Ω/m) (Ω/ft), see tableL: Cable length (m) (ft)I: Consumption current (A), see specificationsCONNECTIONSCopper wire #24 #22 #20 #18size (AWG) (0.22 mm2) (0.33 mm 2) (0.52 mm 2) (0.83 mm 2)Resistance 0.078 0.050 0.030 0.018Ω/mResistance 0.026 0.017 0.010 0.006Ω/ftResistance of copper wire [at 20 °C (68 °F)]1. Connect the power cable to the terminals whileidentifying the polarity.2. Fasten the screws.Video Cable ConnectionsThe maximum extensible coaxial cable length betweenthe camera and the monitor is shown in the table.Type of RG-59/U RG-6/U RG-11/U RG-15/Ucoaxial cable (3C-2V) (5C-2V) (7C-2V) (10C-2V)Recommended (m) 250 500 600 800maximumcable length (ft) 825 1 650 1 980 2 640DC 12VIN12 V DC(10.8 V - 16 V)Control Terminal ConnectionsConnect relevant devices as shown in the figure.ALARM INALARM OUTAUX OUTDAY/NIGHT INGNDSensorRecording device e.g. VCROptical sensorON: B/W,OFF: ColorAux devices e.g. lampALARM INALARM OUTDAY/NIGHT INAUX OUTNotes:• See specifications for each terminal.• Use a relay when the connected device exceedsthe ratings in voltage or current.• The optical sensor validates the Day/Night functionif B/W is set to EXT in the setup menu.Network ConnectionsNetwork Connection Types• Use a router or switching hub when multiple cam-eras are connected.• Use a router handling PPPoE (PPP over Ethernet)when running PPPoE to connect with the Internet,because the camera is incapable of it.• Use network cables complying with category5.• Direct Connection to PC (Type 1)ALARM INALARM OUTAUX OUTDAY/NIGHT INGND A BVIDEO OUTRCVLINK10BASE-T/100BASE-TXPOWERNetwork Cable (Cross type)PCDC 12VIN