Panasonic TX-76PW150A Operating Instructions Manual

Also see for TX-66PW150A: Operating instructions

Panasonic TX-76PW150A Operating Instructions Manual Manual pdf 5 page image

Getting StartedConnect the Aerial5For your safety any external aerial should be installed by a reputable qualified installer and should complywith Australian Standard AS1417.1. The RF (Aerial) Input impedance of this television is 75Ω . If youraerial lead is 300Ω ribbon (two wires separated by a flat plastic sheet) you will require a 300Ω /75Ω Balunin order to connect your aerial to the television.If you are just using the television with no other equipment (VCR, DVD Player, Set Top Box etc) thenconnect the aerial as shown below. If you are connecting VCR then connect the aerial as shown on page34.300Ω /75Ω Balun RF-IN Terminal 75Ω Co-Axial(Not Supplied) CableFor your safety any external aerial should be installed by a reputable qualified installer and should complywith Australian Standard AS1417.1.In New Zealand the installation should comply with International Standard IEC597-1.1.Connect the Power PlugThis television is designed for the Australian Standard Mains Voltage of 240V 50Hz and the New ZealandStandard Mains Voltage of 230V 50Hz.NOTE:If the television is not going to be used for an extended period, remove the power plug from the walloutlet.Turn on the TelevisionPush the Power Switch to turn the television ON. Sit back and enjoy your new Panasonic television.Power SwitchIf the television is not going to be used for a while, turn it off with the power switch. This will reduce theamount of electricity used, reduce greenhouse emissions and save you money.MONITORO U TAV1 INS-VIDEOVIDEOAV3 INLRC O M P O N E N TYP BP RM O N OAUDIOA V 4 I N