Panasonic TX-76PW150A Operating Instructions Manual

Also see for TX-66PW150A: Operating instructions

Panasonic TX-76PW150A Operating Instructions Manual Manual pdf 22 page image

Main Menu – PresetAUTO TUNE22This television has been factory tuned to all major city channels. Use the automatic tuning procedure only if youwish to reset ALL Programme Location Numbers. Refer to “Manual Tune” on page 23 if you only want to retuneone or two Programme Location Numbers.The television should be switched ON and the TV/AV Switch set to TV.When you start the automatic search, the television will automatically search for television broadcasts through bothVHF bands and the UHF band. During this process all of the available television broadcast channels will beautomatically allocated to sequential Programme Number locations starting with location 1.Auto Tuning Using the Front Panel Controls1. Open the front panel door.2. Push the PRE. button repeatedly until AUTO TUNE is highlighted.3. Press the Volume Up ( + ) button to start the Auto Tune. Auto Tune will automatically allocate eachreceived broadcast signal to a sequential Programme Number. The operation will cease when allavailable channels have been tuned.Programme NumberChannel NumberTuning Indicator(Only shown whiletuning)4. Push the PRE. button repeatedly until you return to normal viewing.Auto Tuning Using the Remote Control1. Push the MAIN MENU button.2. Move to the PRESET Menu using the Up or Downbutton.3. Choose the PRESET Menu by using the Left orRight buttons.4. Push the Up or Down button to access the AUTOTUNE option.5. Press the Right button to start the Auto Tune. AutoTune will automatically allocate each receivedbroadcast signal to a sequential ProgrammeNumber. The operation will cease when allavailable channels have been tuned.6. Push the MAIN MENU button repeatedly until youreturn to normal viewing.After you have finished with the automatic tuning and returned to normal viewing, push the ProgrammeNumber Up button to confirm the tuning condition for each Programme Number. If a Programme Numberis unwanted, it is possible to “SKIP” or bypass that Programme Number. Please refer to “SKIP” settingdetails on page 27.1CH 1AUTO TUNE- - | - - - - - - - - - - - - - - - - -PRESETSYS SELECTMANUAL TUNEPOS SETUPGEOMAGNETICAUTO TUNEAUSTRALIAACCESSACCESSACCESS-------|---------