Customer InformationWarnings and Cautions36To keep your Panasonic Television in good working order please observe the following warnings and cautions.Please be careful with this television. Like all electrical equipment it can cause serious injury or damage if it ismistreatedDangerDo not insert foreign objects. (Keepmetal or easily inflammable objectsout of this television).Danger: High VoltageDo not remove the rear cover, as HighVoltage components will be exposed.DO NOT touch the aerial cable andmetal parts of the television whenthere is lightning around.During storms switch the televisionoff. DO NOT leave in standby.Remove the plug from the wall socket.Do not place any containers of wateror other liquids on or near thistelevision.Do not place the TV in humid ordusty locations, or areas exposed tosmoke or steam.Avoid exposing the television to directsunlight or any other sources of directheat.Do not stand or place heavy objectson top of the television.Remove the Power Plug from the wallsocket when the Television is notgoing to be used for an extendedperiod of time.In the advent of unusual operation(e.g. odd sounds, smoke or aromas),turn the television Off and remove thepower cord from the wall socket. Thencall the Television Service Centre: thismay reduce the possibility ofexpensive repair costs.DangerAlways pull the plug out of the walloutlet by holding the plug itself.Do not pull the plug by the powercord.DangerDo not alter the power cord.Do not use if the power cord or plugis damaged or if the plug does not fittightly into the socket.Do not allow the power cord tocome into contact with flame or hotsurfaces.Do not place heavy objects on thepower cord.Adequate ventilation is essential.Allow a gap of at least 10cm aroundthe TV, even in a cabinet or betweenshelves.Do not subject the TV to anyphysical shocks. Always remove anyconnector cables when moving theTV. When moving the TV from oneplace to another wrap it insomething protective.Turn the power OFF beforeconnecting other electricalequipment.Any external aerial should beinstalled by a reputable qualifiedinstaller and should comply withAustralian Standard AS1417.1 orInternational Standard IEC597-1.1.SafetyFirst