Panasonic Electric Works Nordic ABMEW01351 Rev: - Planning Instructions Fire alarm system EBL512 G3, V1.1.x413339 Enclosed Addressable Manual Call Point.23 3339 is like the3333 unit but with another type of back-box (incl. a tighteninggasket). For surface mounting. For indoor use in premiseswhere IP56 rating is required. Operating temp. -10 to +55°C.9.1.1.3 Analog Detectors3308 Analog heat detector. 3308 shall be plugged in an analog base(3312 / 3312F / 3312FL / 4313). Built-in LED that is lit toindicate that the detector has activated a fire alarm. Preparedfor mechanical lock (screw attached) – if required. The COMloop address is set with the Address setting tool (3314). Thedetector has an address label on which the programmed COMloop address can be written.The Address setting tool (3314) is also used for mode setting:NORMAL mode: 3308 is in this mode via WinG3 set to oneof three algorithms (static response temp. range) for class:A1 (54-65°C), min./typical/max. ambient temp. -20/+25/+50°CA2 S (54-70°C), min./typical/max. ambient temp. -20/+25/+50°CB S (69-85°C), min./typical/max. ambient temp. -20/+40/+65°C2330 mode: Not used in system EBL512 G3.2312 mode: Not used in system EBL512 G3.3309 Analog heat detector. Enclosed (IP67)24. Built-in LED that islit to indicate that the detector has generated fire alarm.Terminals for an ext. LED (2218). Recess for label holder(3391). The COM loop address is set with the Address settingtool (3314). The Address setting tool 3314 is also used formode setting:NORMAL mode: 3309 is in this mode via WinG3 set to oneof three algorithms (static response temp. range) for class:A1 (54-65°C), min./typical/max. ambient temp. -20/+25/+50°CA2 S (54-70°C), min./typical/max. ambient temp. -20/+25/+50°CB S (69-85°C), min./typical/max. ambient temp. -20/+40/+65°C2330 mode: Not used in system EBL512 G3.2312 mode: Not used in system EBL512 G3.4300 Analog multi detector. 4300 is a smoke detector and a heatdetector within one housing. Scattered light (i.e. reflection ofinfrared light) is used to detect smoke and the heat sensingelement is a thermistor. The detector unit (actually the heatdetector) can detect a methylated spirits (alcohol) fire (EN54-9,test fire TF6; liquid fire), which normally is impossible for aphoto electric smoke detector to detect.The detector has unleaded soldering.Shall be plugged in an analog base (3312 / 3312F / 3312FL /24 This detector holds the ATEX classification:Ex II 3GD EEx nA II T5 (T 70°C), -20°C < Ta < 65°C.Zone-Addr.001-01 (smoke)001-02 (heat)COM loop addresse.g. 123
