3.2 PBX PARAMETERS AND PORT SETTINGSInstallation Manual 55is busy. PBXs differ in how they handle this function. Test from an SLT to determine thesequence.• Release Sequence for Call Waiting:This sequence is carried out by the VPS to release call waiting. PBXs differ in how theyhandle this function. Test from an SLT to determine the sequence.Inband SignallingThese parameters are used when the Integration Mode is set to Inband. If the PBX type is setto a KX-T series system, these parameters will be automatically set. If another type PBX isused, check that system’s installation manual for settings.Digit Translation Table ParametersThese parameters allow PBXs that have a fixed Follow-on ID sequence to be used with theVPS. For example, a Follow-on ID sequence of [ 201] can be changed to [#6201] by usingthese parameters.• Inter-Digit Time-Out: This parameter defines the duration of incoming signals (Follow-on ID) from the PBX to the VPS. The Digit Translation Table is applied to the digitsreceived within this time.Table 3-4Code(default)Call State Sent to the Voice Mail Port When...1 Ringback Tone The extension dialled is ringing.2 Busy Tone The extension dialled is busy.3Reorder Tone An invalid extension number is dialled or the call isinadvertently connected to another Voice Mail port (alsoheard when no touchtone receiver is available to the VoiceMail extension).4 DND The extension dialled has set DND (Do Not Disturb).5 Answer The extension dialled is answered.6Forwarded toVoice Mail(Ringing)The extension dialled is forwarded to Voice Mail andanother Voice Mail port is able to answer. (This lets the firstVoice Mail port, usually an Auto Attendant, send the call tothe other Voice Mail port.)7Forwarded toVoice Mail (Busy)The extension dialled is forwarded to Voice Mail and noother Voice Mail ports are available to accept the call. (Thissignals the Voice Mail port [usually Auto-Attendant] to let thecaller to leave a message.)8 Forwarded to Extn. The extension dialled is forwarded to another non-VoiceMail extension.9 Confirmation Tone The Message Waiting Lamp On or Message Waiting LampOff code is dialled successfully.#9Disconnect The caller disconnects. The telephone company must senda CPC signal to the PBX for this feature to work on outsidecalls.
