5.2 PORT SETTING OPTIONS116 Installation ManualThis also allows an extension to be assigned as the fax manager to be notified on incomingfaxes.Disconnect Parameter (1-5-7-9)Determines how many seconds of silence the VPS allows during a caller’s message beforedisconnecting the call.RS-232C Settings (1-6-1)Allows the System Administrator to change the baud rate, parity bit, etc.Port Setting (1-6-2)Only to be used when connecting the VPS to a PBX other than a KX-T series PBX. Use theCPC control of the PBX for normal disconnect problems.Dialing Parameters (1-6-3-1)These parameters are set automatically when Quick Setup is conducted.Most of the settings will be left unchanged. The only setting that will be changed quite often isthe Transfer Sequence for the operator or the extension. By default, it is set at FX on DPTIntegration and FTX for Inband Integration. In other words, the voice processor dials the flash(recall), waits for intercom tone and dials the extension number. By default, the VPS will stayon the line to monitor the status of the call. If the extension user answers, the voice processorwill announce "you have a call" prior to releasing the call. This can be alleviated by adding theletter "A" or "D" to the sequence. "A" stands for answer; the call will be transferred without theannouncement "you have a call". For a blind or unscreened transfer, add the letter "D" fordisconnect.5.2.3 Custom Service ProgrammingAfter you have finished constructing the tree, enter the System Programming Custom ServiceSettings Menu.Access the Custom Service Setting Menu through the following sequence:System Administration Top Menu:The system then asks what Custom Service number you want to edit. Enter the desirednumber (1-100).The Custom Service screen is displayed:Enter The Number: = 1 (Program)Enter The Number: = 4 (Service Setting)Enter The Number: = 2 (Custom Service)
