7.2 UTILITY COMMANDS150 Installation Manual3. To create a password or change an existing password:a) Type [1] or [2]NoteWhen you press [2] to change the System Reset/Clear password, you shouldtype the current (OLD) password before entering a new one.b) Type the password.c) Type the password again for verification.4. To clear a password:a) Type [1] or [2].b) Press ENTER. Do not type a password on this screen.c) Press ENTER. Do not type a password on this screen.NoteThe password entered on the screen will not appear. The VPS does notdistinguish capitals from lower cases.7.2.4 Set Time (TIME)Use the TIME command to set the system date and time. A number of system functions requirethat the system time and date be set correctly. These functions include message waitingnotification, external message delivery, call-retries-after initial-failure-to-connect, andautomatic deletion of messages.Time Synchronisation: If you have DPT Integration between the VPS and your PBX (latestsoftware version), the date and time are automatically sent from the PBX to the VPS wheneverthe PBX sets the date and time. Also, this transfer occurs whenever DPT Integration isestablished.1. Type TIME, then Press RETURN.2. Type the current time.Maximum 10 charactersNEW PASSWORD : =VERIFICATION: =Maximum 10 charactersNEW PASSWORD : =VERIFICATION : =$ TIMECurrent time is 12:34, PMEnter new time (HH:MM, AM/PM) : =Current date is MON 1-JAN-2001Enter new date (DD-MM-YY) : =
