Panasonic FP2-PP2T Technical Manual

17-1717.4.7 Positioning Control Starting Table Number Setting AreaIt is used to specify the table number of each axis to start the positioning control.The setting ranges are 1 to 600 in the standard area, and 10001 to 10025 in the extended area.Bank Offsetaddress Name Descriptions DefaultvalueSettingrange Unit00H100HPosition controlstarting tablenumber of 1st axisStore the table number of 1st axisstarting the position control. 11 to 60010001 to10025-101HPosition controlstarting tablenumber of 2nd axisStore the table number of 2nd axisstarting the position control. 11 to 60010001 to10025-102HPosition controlstarting tablenumber of 3rd axisStore the table number of 3rd axisstarting the position control. 11 to 60010001 to10025-103HPosition controlstarting tablenumber of 4th axisStore the table number of 4th axisstarting the position control. 11 to 60010001 to10025-17.4.8 Positioning Control AreaIt is used to specify the repeat count for each axis respectively for the positioning control that starts whenstarting the positioning control. The positioning unit repeats the positioning control started for thespecified repeat count, and then completes the operation.The specified repeat count changes to the default on completion of the operation.Bank Offsetaddress Name Descriptions DefaultvalueSettingrange Unit00H108HRepeat countfor positioningof 1st axisStore the repeat count for the operationstarting from the positioning starting tablenumber of 1st axis to E point.When storing 255, the operation isunlimitedly repeated until stopping theoperation.0 0 to 255 Times109HRepeat countfor positioningof 2nd axisStore the repeat count for the operationstarting from the positioning starting tablenumber of 2nd axis to E point.When storing 255, the operation isunlimitedly repeated until stopping theoperation.0 0 to 255 Times10AHRepeat countfor positioningof 3rd axisStore the repeat count for the operationstarting from the positioning starting tablenumber of 3rd axis to E point.When storing 255, the operation isunlimitedly repeated until stopping theoperation.0 0 to 255 Times10BHRepeat countfor positioningof 4th axisStore the repeat count for the operationstarting from the positioning starting tablenumber of 4th axis to E point.When storing 255, the operation isunlimitedly repeated until stopping theoperation.0 0 to 255 Times