322. Functions in each area2-2-2. Rear panel connections areaSIGNALGNDREFEDITORCOMTALLY/GPIPANELLAN2 3 4 5 6321 4 5 6 7 8 9 10 11 12 13 14 15 16 C/CU/C1SDI OUTPUTSSDI INPUTSDVI-D OUTPUTSIN/OUT B2IN/OUT B1SLOT BIN/OUT A2IN/OUT A1SLOT A SDI signal input connectors [SDI INPUTS 1 to 16]9 to 16: The colour corrector function can be used.13 to 16: The up-converter function can be used. Option slot [SLOT A] (IN/OUT A1, IN/OUT A2) Option slot [SLOT B] (IN/OUT B1, IN/OUT B2)Each of these is an input/output option slot.A DVI input board, analogue output board or other option board can be installed in these slots.For details, refer to “1-3. How to install the option boards” and the operating instructions of the boardconcerned. SDI signal output connectors [SDI OUTPUTS 1 to 4]1 to 4: These can be allocated by the menus. Two sets of the same output signals are distributed from the OUTPUT 1 connector. DVI-D output connectors [DVI-D OUTPUTS 5, 6]These can be allocated by the menus. The DVI-I connector cable cannot be used. Reference input connector/BB outputconnector [REF]Loop-through output in the external sync mode.If the loop-through output is not going to be used,provide a 75-ohm termination.BB signals output from both connectors in the internalsync mode.External synchronization signal inputLoop-through outputInput the external synchronization signal to the upper ofthe two connectors shown above.REF PANEL connector [PANEL] (RJ-45) (100 Base-TX)Connect this to the control panel using the supplied CAT5E cable (STP, straight, 10 m).
