1264. Input/output signal settings4-8-2. Setting the split frame and charactersSet the frame, character brightness and background of the split screens to be displayed on the multi view display.Press the [MV] button to light its indicator and display the MV menu. Refer to “2-1-5. LCD menu area”.Turn [F1] to select the MV1Frame or MV2Frame sub menu depending on the multi view output signals to beset.MV 2|Frame |Char |Label |TallyMV1Frame| LUM75%| LUM75%| On|Red+GRNLUM 0%LUM25%LUM50%LUM100%OffLUM 0%LUM25%LUM50%LUM100%OffOff RedOffMV 4|Frame |Char |Label |TallyMV2Frame| LUM75%| LUM75%| On|Red+GRNLUM 0%LUM25%LUM50%LUM100%OffLUM 0%LUM25%LUM50%LUM100%OffOff RedOffTurn [F2] to set the split frame brightness and split frame display using the Frame item.LUM (0%, 25%, 50%, 75%, 100%):Select one of these settings for the brightness of the split frame (gray scale).Off: The split frame is not displayed.Turn [F3] to set the character brightness and character display using the Char item.LUM (0%, 25%, 50%, 75%, 100%):Select one of these character (gray scale) brightness settings. The “!” mark appears in front of the name of the material when no signals are input or signals witha different format are input. When signals amenable to camera control have been input, the “c” mark is displayed in front ofthe name of the material. When the input signal is frozen, the “F” mark is displayed in front of the name of the material. When the “!” mark is displayed, the “c” mark will not be displayed. When the “F” mark is displayed, the “!” mark and the “c” mark are not displayed.Off: The characters are not displayed. Neither is the character background shown.Turn [F4] to set whether the character background (half-tone) is to be displayed using the Label item.On: The character background is displayed.Off: The character background is not displayed.
