Panasonic AV-HS400AN Operating Instructions Manual

Also see for AVHS400AN - MULTI-FORMAT LIVE SWITCHER: Operating instructions

Contents

Panasonic AV-HS400AN Operating Instructions Manual Manual pdf 82 page image

824. Input/output signal settings4-11. Setting the down-converterSelect the settings for the down-converter that is built into the SDI output board (option).1 Press the [FUNC] button to light its indicator, and press the [IN/OUT] button to display the IN/OUT menu.2 Turn [F1] to display the DownConv sub menu.An asterisk () appears at the left of the parameter currently selected.DownConv Signal Scale↓ Delay↓ Sharp↓15/15 OUT3  SQ  90H  1OUT4OUT5OUT6ECLB1F 1-53 Turn [F2] to select the output signal using the Signal item.4 Turn [F3] to select the scaling system using the Scale item, and press the [F3] switch to enter the setting.SQ (squeeze):The top, bottom, left and right are reduced so that the aspect ratio is set to 4:3.EC (edge crop):The aspect ratio is maintained, the image is reduced in size in line with the vertical resolution, and it iscropped at the left and right.LB (letter box):The aspect ratio is maintained, the image is reduced in size in line with the horizontal resolution, and ablack image is added at the top and bottom.System image (HD) Output image (SD)SQ EC LB5 Turn [F4] to set the delay time of the output using the Delay item, and press the [F4] switch to enter thesetting.90H (75H):When the system format is 1080/59.94i, the image is delayed from the system image (HD) by 90H, andoutput.When the system format is 720/59.94p, the image is delayed from the system image (HD) by 90H+1F(frame), and output.When the system format is 1080/50i, the image is delayed from the system image (HD) by 75H, andoutput.When the system format is 720/50p, the image is delayed from the system image (HD) by 75H+1F(frame), and output.When the system format is 1080/50i or 720/50p, “75H” is displayed on the menu.1F: The image is output in-phase with a delay of 1 frame from the system image (HD).For details on the phase and delay amounts, refer to “4-6. Adjusting the output signal phase”.6 Turn [F5] to set the degree of sharpness of the edges for the image using the Sharp item, and press the [F5]switch to enter the setting.1: Standard up to 5: sharper edgesFor details on the other settings, refer to the operating instructions of the optional board.