141. Functions in each area1-6. LCD menu areaL LCDThe setting menus are displayed on the LCD.When the [FUNC] button (;) is pressed and its indicator islighted and then one of the wipe pattern selector buttons (8)is pressed, the setting menu is displayed.When the buttons listed below are double-clicked, thespecified menu is selected. (The menu delegation function)The operation corresponding to the button pressed is alsoexecuted.POWERALARMF1 F2 F3 F4 F5
Button MenuCrosspoint area(AUX bus selectorbuttons)KEY KEY menu/Adjust sub menu (2/9)CHR KEY menu/Auto sub menu (1/3) (with chroma key selection)DSK DSK menu/Adjust sub menu (2/7)PinP PinP menu/Position sub menu (4/6)Transition area BKGD TIME menu/BKGD sub menu (1/5)KEY TIME menu/KEY sub menu (2/5)WIPE WIPE menu/Border sub menu (1/5)Wipe pattern area WIPE #5 WIPE menu/WIPEPos sub menu (3/5) (BKGD or KEY)SQ #5 WIPE menu/SQPos sub menu (4/5) (BKGD or KEY)SL #5 KEY menu/FlyKEY sub menu (9/9) (KEY)M Rotary encoders [F1] to [F5]These are used to set the parameters displayed on the menus (LCD screen or external monitor).For details on the operations, refer to the sections in “3. Basic operations”.[F1]: Rotate this rotary encoder to switch the sub menu.[F2] to [F5]: Rotate these rotary encoders to set the parameters.When the down arrow (↓) is shown at a menu item, its parameter is set by pressing the corresponding rotaryencoder.When the parameter is one which is set using a numerical value, its default will be restored when the rotaryencoder is held down.(However, the network settings and the date and time settings will not be returned to the defaults.)Adjust Clip Gain Density Invert2/9 0.0 100.0 100.0 OffOperate hereusing [F1]. Operate hereusing [F2].Operate hereusing [F3]. Operate hereusing [F4].Operate hereusing [F5].Sub menu Parameter setting area
