151. Functions in each area1-7. Positioner areaN Positioner [X/Y]These are used when performing the settings below.PinP position settingWipe start position setting (WIPE, SQ #5)Camera controlFlying key position setting POSITIONERZChroma key areaIn each case, the settings take effect only when the following menu items have been selected.The center values of the positioner are set during the time it takes for the unit to start up after its power isturned on. Do not operate the positioner until after the switcher has started up.O Rotary encoder [Z]This is used to set the PinP size, flying key size or to select the chroma key area.In each case, the settings take effect only when the following menu items have been selected.Positioner Rotary encoder Valid menuX/Y Z SwitchPinP Position adjustments Size adjustments(size increased by rotatingthe encoder clockwiseand reduced by rotating itcounterclockwise)Hold switch down torestore initial values (X/Y,Z).All PinP menusWipe Start positionadjustments— Hold switch down torestore initial values (X/Y).WIPE/WIPEPosWIPE/SQPosChroma key Selected area positionadjustmentsSelected area sizeadjustments(size increased by rotatingthe encoder clockwiseand reduced by rotating itcounterclockwise)Hold switch down torestore initial values (X/Y,Z).CHR KEY/Auto(only when Markeritem is set to On)Flying key Position adjustments Size adjustments(size increased by rotatingthe encoder clockwiseand reduced by rotating itcounterclockwise)Hold switch down torestore initial values (X/Y,Z).KEY/FlyKEYCamera control X: Pan control or focuscontrolY: Tilt control or zoomcontrol— Switching between pan/tiltcontrol and zoom/focuscontrolSystem/CamCTL1System/CamCTL2
