Panasonic AG-RCP30P Operating Instructions Manual

Also see for AG-RCP30P: Operating instructions

Panasonic AG-RCP30P Operating Instructions Manual Manual pdf 36 page image

36OSDOSDUse this function to set whether theOn-Screen Display appears on thescreen and is included in record files.Setting : ON/OFFDisplay PositionUse this function to set the displayposition for the On-Screen Display onthe screen and in record files.L-Upper : Upper leftR-Upper : Upper rightL-Bottom : Lower leftR-Bottom : Lower rightTriggerUse this function to turn triggerdisplay on or off upon GPIO 1 to 8inputs.Setting : ON/OFFNote:The Detailed On-Screen Display(see pages 22 and 28) will hide thisindication.< Printable >Use this function to assign a letter tobe shown on the On-Screen Displays.Setting : A - Z, –Notes:• When SPEED is selected, theOn-Screen Display (OSD) settingand printable letters (Printable)setting are both “–”, and cannotbe changed. Also, the screen isnot displayed.• Check the pulse frequencydescribed on page 39 beforeselecting SPEED. Turning SPEED“ON” using an incorrect frequencywill generate an abnormal trigger.Administrator Setup (continued)TriggerGPIOUse this function to turn GPIO onor off.Setting : ON/OFFTrigger1 - 7< Detection >Enter conditions for detection of triggers1 – 7. Set unused triggers to “N”.N : Input disabledH : High-edge triggerLevel H : High-level triggerL : Low-edge triggerLevel L : Low-level triggerB : Double-edge trigger< OSD >Use this function to determine whetheror not GPIO signal status should beindicated in the On-Screen Display.Setting : ON/OFF< Printable >Use this function to assign a letter tobe shown on the On-Screen Display.Setting : A - Z, –Note:The selected font appears when is set to “ON” and the GPIOsignal is high.Trigger8< Detection >Enter conditions for detection oftrigger 8. When not used, set to “N”.N : Input disabledH : High-edge triggerLevel H : High-level triggerL : Low-edge triggerLevel L : Low-level triggerB : Double-edge triggerSPEED : Detects vehicle speed< OSD >Use this function to turn On-ScreenDisplay on or off.Setting : ON/OFF