Panasonic AG-RCP30P Operating Instructions Manual

Also see for AG-RCP30P: Operating instructions

Panasonic AG-RCP30P Operating Instructions Manual Manual pdf 33 page image

33Rec Continue Time∗1Use this function to set recordingcontinue time for normal recordingwhen a trigger is entered or whenthe [REC] button is pressed.Setting (min.) : 1/2/5/10/15/20/30/60/90/CONTINUEPreRec Time (Video)∗2Use this function to set how much ofalready stored video will be retainedwhen a trigger is entered or the[REC] button is pressed.Setting (sec.) : 0/10/20/30/60/90PreRec Time (Audio)∗2Use this function to set how much ofalready stored audio will be retainedwhen a trigger is entered or the[REC] button is pressed. However,the audio recording starts at thesame time when the video pre-recording starts, even if the PreRecTime (Audio) is set longer than thePreRec Time (Video).Setting (sec.) : 0/3/10/20/30/60/90PostRec Time (Video)∗3Use this function to set the timeinterval video recording will continueafter the [STOP] button is pressed.Setting (sec.) : 0/10/20/30/60/90PostRec Time (Audio)∗3Use this function to set the timeinterval audio recording will continueafter the [STOP] button is pressed.However, the audio recording endsat the same time when the videopostrecording ends, even if thePostRec Time (Audio) is set longerthan the PostRec Time (Video).Setting (sec.) : 0/3/10/20/30/60/90Rule of FilenameUse this function to set the rules forfilenames generated during recording.WT : World timeLT : Local timeCAM Select in TriggerUse this function to select a camerawhen a GPIO trigger starts recording.1 : Color Camera connected to the[CAMERA1] connector2 : Commercially available cameraconnected to the [CAMERA2]connectorNO CHANGE : No change is made tothe current settingInit Audio2 RecSets AUDIO2 recording when thepower is turned ON.ON : recording is performedOFF : recording is not performedLAST : See footnote.∗4Administrator Setup (continued)∗1 Intermittent recording and programmed recording extended by Rec ContinueTime do not stop.∗2 Intermittent recording and programmed recording do not include prerecording time.∗3 If recording is stopped by Intermittent recording, programmed recording andRec Continue Time, postrecording is not included.∗4 Applies the setting in effect when power was last turned off. Unless power isturned off properly, the operating state may not be saved correctly.