Panasonic AG-RCP30P Operating Instructions Manual

Also see for AG-RCP30P: Operating instructions

Panasonic AG-RCP30P Operating Instructions Manual Manual pdf 34 page image

34Rec Tally OutEnables or disables output of therecording status as the GPIO9signal. When enabled, a high level(output voltage 5.0 V) indicatesrecording is in progress.Setting : ENABLE/DISABLEInit On Screen TypeUse this function to set On-ScreenDisplay used when the power is on.Setting : SIMPLE/DETAILS/LAST∗1/OFFInit Audio Out (Play)Use this function to set Audio Outused when the power is on.OFF : Audio1 and Audio2 are notoutput.1 : Audio1 is output2 : Audio2 is outputBOTH : Both Audio1 and Audio2 areoutput.LAST : See footnote.∗1Skip TargetUse this function to set the skiplocation (the amount of time that isskipped) when the [Skip back] or [Skipforward] button is pressed.Trigger / MarkerPlayback jumps to the triggerposition (one per file) at whichrecording began, or to a bookmarkposition, whichever found earlier.However, no trigger position canexist in automatically divided files.Setting : YES/NOAdministrator Setup (continued)∗1 Applies the setting in effect when power was last turned off. Unless power isturned off properly, the operating state may not be saved correctly.∗2 The field indicates the time period from start time to stop time.Head of FileUse this function to move to thebeginning of a file during playback.Setting : YES/NONotes:• When both [Trigger/Marker] and[Head of File] are set to “YES”,playback will restart from the firsttrigger or bookmark that appearsor restarts from the beginning ofthe file.• [Trigger/Marker] and [Head of File]cannot both be set to “NO”.Programed RecUse this function to set recording to startand stop every day or on a specifiedday of the week.Daily∗2Makes daily recordings from the setstart time to the set stop time.ON : Start time and stop time can be set.– : No setting is available.Note:When [Daily] is set to “ON”, the[Mon] to [Sun] field changes to “–”and no setting can be made.Mon to Sun∗2Makes recordings from the setstart time to the set stop time on aspecified day of the week.ON : Start time and stop time can be set.A time for the next day can be set.– : No setting is available.