Panasonic AG-RCP30P Operating Instructions Manual

Also see for AG-RCP30P: Operating instructions

Panasonic AG-RCP30P Operating Instructions Manual Manual pdf 29 page image

29Notes:• An interrupted restore process canbe resumed at a later time.• Recording is still available even ifthere are files in need of restoration.• A recording trigger detected duringa restore process or pressing the[REC] button will interrupt theprocess and start recording.• Files that must be restored do notappear on the playback file listscreen. Make sure to restore thefiles beforehand.• Since a seriously corrupted filemay not be possible to restore,do not turn off the unit during P2card access (for example, duringrecording) and do not remove aP2 card when the [BUSY] lamp islit or blinking.If the power of the Memory Card VideoRecorder is turned off or a P2 card isremoved during recording, the file will becorrupted and cannot be played back.[Restore] appears on the On-ScreenDisplay when there is a file on the P2card that needs to be restored.(This message does not appear when[On Screen Type] is set to “OFF”.)[Restore] in the Menu is normallydisabled, but is enabled upon detectinga file that cannot be played back.Use the following steps to process anyfile that needs to be restored.1. Press the [MENU] button.The Menu appears.2. Use the [ , ] buttons to select[Restore] and press [ ] toconfirm the entry.The Restore confirmation screenappears.3. Use the [ , ] buttons to select[Restore] and press [ ] toconfirm the entry.This starts file restoring.The screen prior to Step 1 abovereappears when the file is restored.Select [Cancel] during a restoring tocancel the restore process.Restoring Files