NEC NP3200 User Manual

Also see for NP1200 Series: Control commands Command guide Command guide Supplementary guide Technical data sheet

Contents

NEC NP3200 User Manual Manual pdf 87 page image

8 Menu Descriptions & Functions [RESET]Returning to Factory Default [RESET]The RESET feature allows you to change adjustments and settings to the factory preset for a (all) source (s) exceptthe following:[CURRENT SIGNAL]Resets the adjustments for the current signal to the factory preset levels.The items that can be reset are: [PRESET], [CONTRAST], [BRIGHTNESS], [SHARPNESS], [COLOR], [HUE],[CLOCK], [PHASE], [HORIZONTAL], [VERTICAL], [OVERSCAN], and [ASPECT RATIO].[ALL DATA]Reset all the adjustments and settings for all the signals to the factory preset.All items can be reset EXCEPT [LANGUAGE], [BACKGROUND], [FILTER MESSAGE], [SECURITY], [COM-MUNICATION SPEED], [CONTROL ID], [FAN MODE], [STANDBY MODE], [LAMP LIFE REMAINING], [LAMPHOURS USED], [FILTER HOURS USED], [TOTAL CARBON SAVINGS], and [NETWORK SETTINGS].To reset the lamp usage time, see “Clearing Lamp Hour Meter [CLEAR LAMP HOURS]” below.Clearing Networking Settings [NETWORK SETTINGS]Returns [DHCP], [IP ADDRESS], [SUBNET MASK], and [GATEWAY] to the default settings.Clearing Lamp Hour Meter [CLEAR LAMP HOURS]Resets the lamp clock back to zero. Selecting this option displays submenu for a confirmation. Select [YES] andpress the ENTER button.NOTE: Elapsed time of the lamp use will not be affected even when [RESET] is done from the menu.NOTE: The projector will turn off and go into standby mode when you continue to use the projector for another 100 hours afterthe lamp has reached the end of its life. In this condition you cannot clear the lamp hour meter on the menu. If this happens,press the HELP button on the remote control for 10 seconds to reset the lamp clock back to zero. Do this only after replacing thelamp.Clearing the Filter Usage Hours [CLEAR FILTER HOURS]Resets the filter usage back to zero. Selecting this option displays submenu for a confirmation. Select [YES] andpress the ENTER button.NOTE: Elapsed time of the filter use will not be affected even when [RESET] is done from the menu.765. Using On-Screen MenuDownloaded From projector-manual.com NEC Manuals