28 Correcting Keystone DistortionCorrecting Keystone DistortionIf the screen is tilted vertically, keystone distortion becomes large. Proceed with the followingsteps to correct keystone distortionNOTE:• The Keystone correction can cause an image to be slightly blurred because the correction is made electronically.• The Keystone correction range can be made narrower, depending on a signal or its aspect ratio selection.Adjusting with the remote control1. Press the KEYSTONE button.The Keystone bar will be displayed.2. Use the or button to correct the keystone distortion.Adjust so that the right and left sides are parallel.3. Press the ENTER button.NOTE:• The Keystone correction can cause an image to be slightly blurred because the correction is made electronically.• The maximum range of vertical keystone correction is +/−30 degrees. This maximum range can be changed depending on thesignal or aspect ratio setting.• To reset the KEYSTONE correction setting values, press and hold the KEYSTONE button for a minimum of 2 seconds.• The range of keystone correction is not the maximum tilt angle of projector.• The left and right (horizontal) keystone correction is not available.TIP: The changes can be saved with [KEYSTONE SAVE]. (→ page 63)3. Projecting an Image (Basic Operation)ON OFF AUTO ADJ.COMPUTERVIDEO S-VIDEO VIEWERID SET CLEARAV-MUTE FREEZEENTEREXITECO MODEKEYSTONE PICTUREVOL.HELP FOCUS ASPECT1 2 34 5 67 8 90MENUZOOML-CLICK R-CLICKMOUSEPAGEMAGNI FYPOWERON OFF AUTO ADJ.COMPUTERVIDEO S-VIDEO VIEWERID SET CLEARAV-MUTE FREEZEENTEREXITECO MODEKEYSTONE PICTUREVOL.HELP FOCUS ASPECT1 2 34 5 67 8 90MENUZOOML-CLICK R- CLICKMOUSEPAGEMA GNIFYPOWERENTERON OFF AUTO ADJ.COMPUTERVIDEO S-VIDEO VIEWERID SET CLEARAV-MUTE FREEZEEXITECO MODEKEYSTONE PICTUREVOL.HELP FOCUS ASPECT1 2 34 5 67 8 90MENUZOOML-CLICK R-CLICKMOUSEPAGEMAGNIFYPOWERDownloaded From projector-manual.com NEC Manuals
