41. Introduction Part Names of the ProjectorControls(→ page 7)Built-in Security Slot ( )*Zoom Lever(→ page 26)Lens CapRemote Sensor(→ page 10)Focus Ring(→ page 26)Lens Shift Dial (Right / Left, Up / Down)(→ page 25)Adjustable Tilt Foot Lever(→ page 27)* This security slot supports the MicroSaver® Security System. MicroSaver® is a registered trademark of Kens-ington Microware Inc. The logo is trademarked and owned by Kensington Microware Inc.Ventilation (inlet) / Filter(→ page 77)Adjustable Tilt Foot(→ page 27)LensFront/TopVentilation (inlet) / Filter(→ page 77)Stereo Speaker (5W × 2)AC InputConnect the supplied power cable’s three-pin plug here,and plug the other end into an active wall outlet.(→ page 20)Main Power SwitchWhen you plug the supplied power cable into an activewall outlet and turn on the Main Power switch, the POW-ER indicator turns orange and the projector is in standbymode.(→ page 21)Remote Sensor(→ page 10)Ventilation (outlet)Heated air is exhausted fromhere.RearTerminal Panel(→ page 8)Lamp Cover(→ page 79)LENS RELEASE Button(→ page 84)Downloaded From projector-manual.com NEC Manuals
