Changing Eco ModeThis feature enables you to select two brightness modes of the lamp:OFF and ON modes. The lamp life can be extended by turning on the [ECO MODE].[ECO MODE] Description Status of LAMP indicator[OFF] This is the default setting (100% Brightness). OffSTATUSLAMP[ON] Select this mode to increase the lamp life (approx.80% Brightness on NP3200 and approx. 88%Brightness on NP2200/NP1200).Steady Green lightSTATUSLAMPON OFF AUTO ADJ.COMPUTERVIDEO S-VIDEO VIEWERID SET CLEARAV-MUTE FREEZEENTEREXITECO MODEKEYSTONE PICTUREVOL.HELP FOCUS ASPECT1 2 34 5 67 8 90MENUZOOML-CLICK R- CLICKMOUSEPAGEMAGN I FYPOWERTo turn on the [ECO MODE], do the following:1. Press the ECO MODE button on the remote control to display[ECO MODE] screen.2. Use the or button to select [ON].3. Press the ENTER button.To change from [ON] to [OFF], Go back to Step 2 and select [OFF].Repeat Step 3.NOTE:• The [ECO MODE] can be changed by using the menu.Select [SETUP] → [GENERAL] → [ECO MODE].• The lamp life remaining and lamp hours used can be checked in [USAGETIME]. Select [INFO.] →[USAGE TIME].• [ECO MODE] is always set to [OFF] for 1 minute immediately after the lamp isturned on. The lamp condition will not be affected even when [ECO MODE] ischanged.• After a lapse of 1 minute from when the projector displays a blue, black orlogo screen, [ECO MODE] will automatically switch to [ON].• If the projector is overheated in [OFF] mode, there may be a case where the[ECO MODE] automatically changes to [ON] mode to protect the projector.When the projector is in [ON] mode, the picture brightness decreases. Whenthe projector comes back to normal temperature, the [ECO MODE] returns to[OFF] mode.Thermometer symbol [ ] indicates the [ECO MODE] is automatically set to[ON] mode because the internal temperature is too high.334. Convenient FeaturesDownloaded From projector-manual.com NEC Manuals
