27221Adjusting the Tilt Foot1. Lift the front edge of the projector.CAUTION:Do not try to touch the ventilation outlet during Tilt Foot adjustmentas it can become heated while the projector is turned on and after itis turned off.2. Push up the Adjustable Tilt Foot Levers on the right and left sidesof the projector to extend the adjustable tilt feet (maximum height).3. Lower the front of the projector to the desired height.4. Release the Adjustable Tilt Foot lever to lock the Adjustable tilt foot.There is approximately 10 degrees (up) of adjustment for the front ofthe projector.Adjustable TiltFoot LeverAdjustable TiltFoot LeverNOTE: Your “Keystone” correction data can be reset by pressing and holdingthe KEYSTONE button for a minimum of 2 seconds.CAUTION:Do not use the tilt-foot for purposes other than originally intended.Misuses such as using the tilt foot to carry or hang (from the wall orceiling) the projector can cause damage to the projector.TIP: For operating the [KEYSTONE] screen, see “ Correcting Keystone Dis-tortion” on page 28.3. Projecting an Image (Basic Operation)434Adjustable Tilt FootDownloaded From projector-manual.com NEC Manuals
