202. Installation and ConnectionsConnecting the Supplied Power CableConnect the supplied power cable to the projector.First connect the supplied power cable’s three-pin plug to the AC IN of the projector, and then connect the otherplug of the supplied power cable in the wall outlet.NOTE: To turn off the AC power supply when the projector is powered on, use the Main Power Switch or a power strip equippedwith a switch and a breaker.CAUTION:Do not try to touch the ventilation outlet on the left front (when seen from the front) as it can become heatedwhile the projector is turned on and immediately after the projector is turned off.CAUTION:Do not unplug the power cable from the wall outlet or projector when the projector is powered on. Doing so cancause damage to the AC IN connector of the projector and (or) the prong plug of the power cable.About Direct Power OffThe projector has a feature called “Direct Power Off”. This feature allows the projector to be turned off (even whenprojecting an image) using the Main Power Switch or disconnecting the AC power supply.NOTE: Before using Direct Power Off, be sure to allow at least 20 minutes immediately after turning on the projector and startingto display an image.Make sure that the prongs are fully inserted into boththe AC IN and the wall outlet.To wall outlet ←Downloaded From projector-manual.com NEC Manuals
