Menu
Lenovo ThinkSystem SR665 V3 User Manual
Also see for 7D9A: System configuration guideUser guide
                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                            |
Figure 181. Removing the 4 x 2.5-inch rear drive backplanea. Open the release latches in the direction shown.b. Rotate the backplane from the top to disengage it from the pins on the drive cage.c. Carefully lift the backplane out of the drive cage.After you finishIf you are instructed to return the component or optional device, follow all packaging instructions, and useany packaging materials for shipping that are supplied to you.Install the 4 x 2.5" drive backplane and drive cageFollow instructions in this section to install the rear 2.5-inch 4-bay drive backplane and drive cage.About this taskAttention:• Read “Installation Guidelines” on page 47 and “Safety inspection checklist” on page 48 to ensure that youwork safely.• Power off the server and peripheral devices and disconnect the power cords and all external cables. See“Power off the server” on page 62.• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices withan electrostatic-discharge wrist strap or other grounding system.• The rear drive cage is supported on some server models with thermal requirements. See “Thermal rules”on page 59 to ensure that the server is under permitted ambient temperature and the correct heat sinkand system fans are used. If needed, replace your heat sink or system fan first.– “Processor and heat sink replacement (trained technician only)” on page 175– “System fan replacement” on page 264ProcedureStep 1. Touch the static-protective package that contains the new part to any unpainted surface on theoutside of the server. Then, take the new part out of the package and place it on a static-protectivesurface.Step 2. Install the drive backplane into the rear drive cage.Chapter 5. Hardware replacement procedures 215 |
Related manuals for Lenovo 7D9A
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved