Menu
Lenovo ThinkSystem SR665 V3 User Manual
Also see for 7D9A: System configuration guideUser guide
                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                            |
Note: Ensure that the OCP module is fully seated and the thumbscrew is securely tightened.Otherwise, the OCP module will not get full connection and may not function.After you finishComplete the parts replacement. See “Complete the parts replacement” on page 279.OCP interposer card replacementFollow instructions in this section to remove and install the front and rear OCP interposer cards.• “Remove the front OCP interposer card” on page 94• “Install the front OCP interposer card” on page 97• “Remove the rear OCP interposer card” on page 101• “Install the rear OCP interposer card” on page 102Remove the front OCP interposer cardFollow instructions in this section to remove the front OCP interposer card.About this taskAttention:• Read “Installation Guidelines” on page 47 and “Safety inspection checklist” on page 48 to ensure that youwork safely.• Power off the server and peripheral devices and disconnect the power cords and all external cables. See“Power off the server” on page 62.• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices withan electrostatic-discharge wrist strap or other grounding system.ProcedureStep 1. Make preparation for the task.a. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to thetop cover, or remove the server from the rack. See “Remove the server from rack” on page 63.b. Remove the top cover. See “Remove the top cover” on page 277.c. If your server comes with a riser 1 assembly, remove it first. See “Remove a rear riserassembly” on page 232. Then disconnect the cables from the rear OCP interposer card.d. Record the cable connections, and disconnect all cables from the system board assembly.Notes:• If you need to disconnect cables from the system board assembly, disengage all latches orrelease tabs on cable connectors first. Failing to release the tab before removing the cableswill damage the cable sockets on the system board assembly. Any damage to the cablesockets might require replacing the processor board or system I/O board.• The connectors on your system board assembly might look different from those in theillustration, but the removal procedure is the same.1. Press the release tab to release the connector.2. Disengage the connector from the cable socket.e. Remove system fans. See “Remove a system fan” on page 264.94 ThinkSystem SR665 V3 User Guide |
Related manuals for Lenovo 7D9A
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved