Menu
Lenovo ThinkSystem SR665 V3 User Manual
Also see for 7D9A: System configuration guideUser guide
                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                            |
About this taskImportant: This task must be operated by trained technicians that are certified by Lenovo Service. Do noattempt to remove or install it without proper training and qualification.S002CAUTION:The power-control button on the device and the power switch on the power supply do not turn off theelectrical current supplied to the device. The device also might have more than one power cord. Toremove all electrical current from the device, ensure that all power cords are disconnected from thepower source.Attention:• Read “Installation Guidelines” on page 47 and “Safety inspection checklist” on page 48 to ensure that youwork safely.• Power off the server and peripheral devices and disconnect the power cords and all external cables. See“Power off the server” on page 62.• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices withan electrostatic-discharge wrist strap or other grounding system.ProcedureStep 1. Make preparation for the task.a. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to thetop cover, or remove the server from the rack. See “Remove the server from rack” on page 63.b. Remove the top cover. See “Remove the top cover” on page 277.c. If your server comes with an air baffle or a middle cage, remove it first.• “Remove the air baffle” on page 70• “Remove the middle drive cage and drive backplanes” on page 162d. Remove the system fan cage (only for removing the performance heat sink). See “Remove thesystem fan cage” on page 269.Step 2. Remove the heat sink.Notes:• Do not touch the contacts on the bottom of the processor.• Keep the processor socket clean from any object to prevent possible damages.Chapter 5. Hardware replacement procedures 177 |
Related manuals for Lenovo 7D9A
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved