Lenovo ThinkSystem SR665 V3 User Manual

Also see for 7D9A: System configuration guide User guide

Step 6. Install the riser assembly with the GPU adapter.GPU adapter on riser 1 or 2 assemblyNote: The following uses riser 1 assembly as an example for illustration. The replacementprocedure is the same for riser 2 assembly.Figure 92. Installing the riser 1 assembly with GPU adaptera. Align the riser card with the PCIe slot on the system board assembly. Carefully press theriser card straight into the slot until it is securely seated.b. Open the blue latch on the GPU air baffle and fix the end of the GPU adapter. Then, closethe blue latch.c. Tighten the screw to fix the riser cage.GPU adapter on riser 3 assemblya. Connect cables from the riser 3 and GPU adapter to the system board assembly. See Chapter6 “Internal cable routing” on page 281.b. Install the GPU air baffle. See “Install the air baffle” on page 72.Chapter 5. Hardware replacement procedures 131

/ 540

Related manuals for Lenovo 7D9A

Lenovo ThinkSystem D3 User Manual

Lenovo ThinkSystem DM Series Installation Instructions Manual

Lenovo 7893 Quick Start Instructions

This manual is suitable for:

7D9A 7D9B ThinkSystem SR665 V3

Lenovo ThinkSystem SR665 V3 User Manual

Product

Learn More

Legal