Menu
Lenovo ThinkSystem SR665 V3 User Manual
Also see for 7D9A: System configuration guideUser guide
                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                            |
After you finish1. Complete the parts replacement. See “Complete the parts replacement” on page 279.2. Access the Lenovo XClarity Controller; then, select Network in BMC Configuration and enableEthernet Port 2.MicroSD card replacementFollow the instructions in this section to remove and install the MicroSD card.• “Remove the MicroSD card” on page 159• “Install the MicroSD card” on page 160Remove the MicroSD cardFollow the instructions in this section to remove the MicroSD card.About this taskAttention:• Read “Installation Guidelines” on page 47 and “Safety inspection checklist” on page 48 to ensure that youwork safely.• Power off the server and peripheral devices and disconnect the power cords and all external cables. See“Power off the server” on page 62.• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices withan electrostatic-discharge wrist strap or other grounding system.ProcedureStep 1. Prepare your server.a. Remove the top cover. See “Remove the top cover” on page 277.b. If your server comes with riser assemblies, remove them first, see “Remove a rear riserassembly” on page 232.c. If your server comes with a rear drive assembly, remove it first. See “Rear drive backplane anddrive cage replacement” on page 213.d. If your server comes with a 7mm rear drive assembly, remove it first. See “Remove the 7mmdrive cage” on page 205.e. Record where the cables are connected to the system board assembly; then, disconnect allthe cables.Attention: Disengage all latches, cable clips, release tabs, or locks on cable connectorsbeforehand. Failing to release them before removing the cables will damage the cableconnectors on the system board assembly. Any damage to the cable connectors may requirereplacing the system board assembly.Step 2. Remove the MicroSD card.Chapter 5. Hardware replacement procedures 159 |
Related manuals for Lenovo 7D9A
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved