Lenovo ThinkSystem SR665 V3 User Manual

Also see for 7D9A: System configuration guide User guide

Remove a hot-swap driveFollow instructions in this section to remove a hot-swap drive.About this taskAttention:• Read “Installation Guidelines” on page 47 and “Safety inspection checklist” on page 48 to ensure that youwork safely.• Before you remove or make changes to drives, drive controllers (including controllers that are integratedon the system board assembly), drive backplanes or drive cables, back up all important data that is storedon drives.• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configurationinformation.• If one or more NVMe solid-state drives are to be removed, it is recommended to disable them beforehandvia the operating system.• To ensure that there is adequate system cooling, do not operate the server for more than two minuteswithout either a drive or a drive filler installed in each bay.Note: Make sure you have the drive bay fillers available if some drive bays will be left empty after theremoval.ProcedureStep 1. If the security bezel is installed, remove it first. See “Remove the security bezel” on page 245.Step 2. Slide the release latch to unlock the drive handle.2.5-inch hot-swap drive 3.5-inch hot-swap driveStep 3. Grasp the handle and slide the drive out of the drive bay.Chapter 5. Hardware replacement procedures 133

/ 540

Related manuals for Lenovo 7D9A

Lenovo ThinkSystem D3 User Manual

Lenovo ThinkSystem DM Series Installation Instructions Manual

Lenovo 7893 Quick Start Instructions

This manual is suitable for:

7D9A 7D9B ThinkSystem SR665 V3

Lenovo ThinkSystem SR665 V3 User Manual

Product

Learn More

Legal