S-Quad Sensor with Strobe - STATES (legacy devices)The STATE in which the S-Quad sensors operate can be changed from the default factory set STATE to another STATE during commissioning. The environment in which the S-Quad device is installedwill determine what STATE is applicable. # - Factory Default STATE ~ EN54 : Part 7 :2000 * EN54 : Part 5 :2002 ¯ - used in current range&The release of control panel software (MCC/MCB equal to or greater than V4.41):If a non defined STATE is selected during commissioning then the control panel will revert to STATE 0.The previous release of control panel software (MCC/MCB less than V4.41):If a non defined STATE is selected during commissioning then the control panel will revert to STATE 15, which means the device is functionally switched OFF.Device LPCB approved STATEMeets ~ EN54 : Part 7 :2000* EN54 : Part 5 :2002Dual Optical & Heat sensor variant -S4-711¯(With Strobe) S4-711-ST(With Speech) S4-711-VO(With Strobe & Speech) S4-711-ST-VO(With Sounder) S4-771State 0 # Medium optical smoke ~ / Class A1 heat *State 5 Medium optical smoke ~ / Class B heat *State 8 Delayed medium optical smoke ~ / Class A1 heat*Dual Optical, Heat & CO sensor variant -S4-911(With Speech & Strobe) S4-911-ST-VOState 0 # Medium optical smoke ~ / Class A1 heat *State 9 Class A1 heat *Optical & Heat sensor variant -S4-710¯(With Sounder) S4-770State 0 # Medium optical smoke / Class A1 heat*Heat sensor variant -S4-720¯(With Speech & Strobe) S4-720-ST-VO(With Sounder) S4-780State 0 # Class A1 heat *State 5 Class B heat *Optical senor - S4-715¯ State 0 Medium optical smokeAll S-Quad range of sensor sounder devices meet CEA 4021, where applicable, and meet EN54-17:2005 Short circuit isolation plus EN54-18:2005 Input/Output devices for use on the transmission pathof fire detection and alarm systems.Commissioning instructions74 4188-856_issue 7_07/15_Generic Vigilon (Compact + VA) Comms.S-Quad Sensor with Strobe - STATES (legacy devices)
