Honeywell Vigilon 4 loop Generic Commissioning Instructions

Contents

Honeywell Vigilon 4 loop Generic Commissioning Instructions Manual pdf 52 page image

Indications on power upThese are typical power up indications given at the VIGILON, VIGILON Compact and VIGILONCompact VA panels with no loop circuits connected."At this stage of commissioning the audio loop circuit of VIGILON Compact VA panelmust remain disconnected.¨ Switch On the mains power to the panel and then connect the battery supply:• the panel buzzer sounds• some LEDs on the panel will be momentarily lit and the display reads:Powering up - please wait........• the dots below the powering up message indicates progress.• the Disablement light gives a flashing indication and after a short duration changeto a steady indication and the display gives messages similar to:Time not setNVM Card FittedAudio Card Keypad fitted -(Compact VA only)Loop 1; 0V resistance is 28.4R, L is 1NVM is not write protectedCard found at Card 1 x.xx (aa/bb/cc)Allocating Loop nACC Loop O/S 2 -(Compact VA only)• NVM Card - Non Volatile Memory Card found• Card 1 - Loop card 1 found• Loop 1 has a measured 0V line loop resistance form end to end is 28.4R. Therelative inductance ratio is 1• the x.xx is the software version number of the card• Audio controller card (ACC) Loop has 2 outstations found this appears onVIGILON compact VA panel only.• the aa/bb/cc signifies the day, month and year of software release.Allocation: OK at Card X : Allocated zzzThere may be other indications and messages depending on the panel condition.• Disablement indicator is lit.Initial tests" The menus at the control panel are accessible by pressing the Menu On/Offbutton. For details of the menu options see Appendix A - Menu Maps .# - will appear if a PIN is setup.Display test¨ To test the display press the Menu On/Off button and then select [Test/Eng] ->[DispTest]. The Display Test option will cause all the LEDs and buzzer (includingbacklight) to remain On for a short duration.Setting the Clock¨ To set up the time and date, press the Menu On/Off button and then select [SetUp]-> [Usercode]# ->[Set Clock]. The Set Clock option will allow the setting of the timeand date at the panel.Printer test (if fitted)¨ To test the printer, press the Menu On/Off button and then select [Control] ->[Usercode]# -> [Printer], if the printer is On select [Test] to carry out a printer test.Power supply test¨ Test the panel’s mains and battery supply by carrying out temporary disconnectionand reconnection, to allow event indications to be given on the panel. Ensuresufficient time is given for the event to be displayed, normally within 2 minutes.Master alarms circuit tests¨ Check that indications are given when there is a fault on the master alarm circuit.Carry out an open circuit test by disconnecting the end of line resistor. Then carry outa short circuit test by shorting the master alarm circuit terminals.Commissioning instructions52 4188-856_issue 7_07/15_Generic Vigilon (Compact + VA) Comms.Indications on power up