Setting the DKC cardThe links, pot and switch on the DKC are factory configured as shown below.Control buttons"The emergency control buttons must always be left in an enabled state, with the 'controlbuttons' link fitted.There is no indication given at the panel when the link is set for inactive controls.Display Contrast¨ The display contrast is set using the Pot RV1 on the DAC, which is factory adjustedfor optimum contrast. You can also adjust the contrast using the menu option under[Test/Eng], see Appendix A menu maps." The contrast adjustment function using the menu options may not beapplicable for some older build of panels.Domain Address and baud rate settingsTypically the Baud rate set using these switches should be the same as the setting made using the[TestEng] menu. The baud rate set must be backed up to the NVM. Where a baud rate value thatcan only be achieved by [Test/Eng] menu, this must be set using the menu and backed up to NVM.Baud Rate Domain address1 2 Baud 3 4 5 6 7 8 AddressOff Off 1200 Off Off Off Off Off Off 64Off On 2400 Off Off Off Off Off On 1On Off 9600 Off Off Off Off On Off 2On On 19200 etcOn On On On On Off 62On On On On On On 63Factory set domain address - 1 with 19200 baud (see SHADED cells)Zone indicatorsThe Zone indicators are enabled for normal operation at an EN control panel and must NOT bedisabled.The zone indicators are not applicable on a Network node nor on a BS Control panel. On theseproducts the 'zone indicator' links are set in the 'disable' position.Commissioning instructions26 4188-856_issue 7_07/15_Generic Vigilon (Compact + VA) Comms.Vigilon 4/6 loop PanelsDKC ASSEMBLYWARNINGREMOVAL OF COVEREXPOSES HIGH VH VOLTAGESInner door assemblyDangerRV1Sound AlarmsSilence AlarmsResetVerifyControl buttonsInner door1 2 3 417 18 19 20ZonesWith Zoneindicators(EN)Display andkeyboard Card (DKC)Without Zoneindicators(BS) panel orNetwork nodeP6P1ButtonsenabledButtonsdisabledFactory settingis with link fitted87654321ONSW1RV1LCD Contrast adjustOFFClockwise -DarkerAnti-Clockwise -LighterLink is NOT USEDleave link fitted.It is for special usewith keyswitchapplication
