2-41. Set Up the Cameraa WARNING:Install the camera securely.● When installing the VB-C50Fi on the ceiling or a wall, contact your Canon dealer.● When installing the VB-C50Fi on the ceiling or a wall, check that it is strong enough tobear the weight of the VB-C50Fi including the mounting arm. Installation in a weak locationcould result in the VB-C50Fi falling and causing serious injury. Check that the ceiling canhold either 3 times the weight of the camera and arm or 8kgs (whichever is heavier) for 1minute.● When attaching the arm to the ceiling, make sure that the screws are tightly fastened.The arm and camera may fall if the screws are not tightly fastened, which may causeserious injury.● At least once a year, check for looseness in the camera installation mount. (If the optionalwide converter is used, check the converter mount also).● Do not install the arm in a place that shakes or vibrates frequently as the screws maycome loose causing the camera to fall or be damaged, which in turn may cause seriousinjury.Note● The MAC address required when making network settings is shown on the rear of theVB-C50Fi (→ P.1-9). Please make a note of it before installing this unit (→ P.2-8).● Always use a tripod mounting screw that is less than 6.0 mm ( 1 / 4 in.) in length. Theuse of screws 6.0 mm ( 1 / 4 in.) long or longer could damage the camera. Also, thetripod seat used should be at least 30 mm (1 3 / 16 in.) in diameter.Firstly, set up the camera. Read the following carefully and make sure the camera is set up properly.MountingscrewLess than6.0 mm( 1/ 4 in.)30 mm(1 3/ 16 in.)or widerMounting the Camera to the Ceiling or WallAttach a mounting arm (not included) to the ceiling or awall and firmly attach the camera to the arm.When Using a Tripod
