76 Trouble?PrintingEditingOthersList of MessagesProblem SolutionThe printer is not operatingeven though the camcorderand printer are correctlyconnected.Disconnect the USB cable and turn off the camcorder and theprinter. After a short while, turn them on again, set thecamcorder to mode and restore the connection.–Problem SolutionCannot record with thiscamcorder video input from anexternal video deviceconnected to the HDV/TVterminal using a DV cable.Set [AV DV] to [OFF]. 33Wrong signal standard. Dubbing may work using the AV IN/OUTterminal.Refer also to the instruction manual of the connected device.–Problem SolutionA rattling can be heard from thecamcorder.The internal lens fixture can move when the camcorder is turnedoff. This is not a malfunction.–Message Explanation/SolutionSET THE TIME ZONE,DATE AND TIMEYou have not set the time zone, date and time. This messageappears each time you turn the power on until you set the timezone, date and time.24CHANGE THE BATTERYPACKBattery pack is exhausted. Replace or charge the battery pack. 18THE TAPE IS SET FORERASURE PREVENTIONCassette is protected. Replace the cassette or change the positionof the protect switch.80REMOVE THE CASSETTE Camcorder stopped operating to protect the tape. Remove thecassette and reinsert it.19CHECK THE HDV/DVINPUT(Appears only if a DV cable isconnected)The DV cable is not correctly connected to the HDV/DV terminal, orthe connected digital device is turned off.57The video input signal is in a different television system (PAL orSECAM).–CONDENSATION HASBEEN DETECTEDCondensation has been detected in the camcorder. 82CONDENSATION HASBEEN DETECTEDREMOVE THE CASSETTECondensation has been detected in the camcorder. Remove thecassette.82TAPE END Tape reached the end. Rewind the tape or replace the cassette. –
