Recording26 When using a tripod: Do notleave the viewfinder exposed todirect sunlight as it may melt(due to concentration of the lightby the lens). Do not use tripodswith fastening screws longerthan 5.5 mm (0.2 inch). Doingso may damage the camcorder.Recording Still Images1 Holding the lock button presseddown, set the POWER switch toCAMERA.2 Move the / switch to(memory card).3 Press halfway.• Once the focus is automaticallyadjusted, will turn green and one ormore AF frames appear.• When you press on thewireless controller, the still image isrecorded immediately.4 Press fully.The CARD access indicator will flashas the image is being recorded.IMPORTANTAvoid the following actions while the cardaccess display ( ) appears on screen andwhen the CARD access indicator is on orflashing. Failing to do so may result inpermanent data loss.- Do not open the memory card slot cover anddo not remove the memory card.- Do not disconnect the power source or turn offthe camcorder.- Do not change the position of the /switch or the operating mode.NOTES If the subject is not suitable for autofocus,turns yellow. Adjust the focus manually ( 44). When the subject is too bright, “OVEREXP.”starts flashing. In such case, use the optionalFS-H37U ND filter.ZoomingPOINTS TO CHECK: In addition to the 10x opticalzoom, the 200x digital zoom is alsoavailable ( 31).Before using a memory card for the firsttime, be sure to initialize it with thiscamcorder ( 56).( 10)PHOTOPHOTOPHOTO( 10)Zoom outZoom in
