02/20003-24 DocuPrint N2125IQ RAP 14 , IQ RAP 15Initial IssueImage Quality Repair Analysis ProceduresY NReplace the damaged or worn roll.Install a new Print Cartridge. Run a Test Print. The print is still damaged.Y NProblem Solved.Replace the following, in order, until the defective component is found: Fuser Assembly(REP 6.2), Chute Transport Assembly (REP 6.1), BTR Assembly (REP 7.1), MBF FeedRoll Assembly (REP 4.2), Retard Pad Assembly (REP 4.7), Turn Roll Assembly (REP11.8), Paper Feed Rolls (REP 11.11), Tray Assembly /REP 4.4).Go to IQ RAP 13.IQ RAP 15 RegistrationThe image is not positioned correctly on the paper. It may be off in either the process directionor in the scan direction (Figure 1).Figure 1 RegistrationInitial Actions• Check to ensure that the paper is within specification.• Check that the paper supply is dry and fresh and loaded correctly.• Check that the Paper Tray guides are set correctly.• Check that rollers and other components in the paper path are clean and unobstructed.ProcedureRun a test print. The Test Print output image is properly registered.Y NPerform the registration check (ADJ 1.1). The printer registration is set correctly.Y NPerform the registration procedure (ADJ 1.1).If misregistration occurs in the process direction, replace in sequence as necessary: Rub-ber Registration Rolls (REP 5.6), Registration Clutch (REP 5.5), Main Drive Gear Assem-bly (REP 8.2), Main Motor Assembly (REP 8.1), Registration Sensor (REP 5.4), PrintEngine Controller PWB (REP 9.3), or System Controller PWB (REP 9.2).If misregistration occurs across the process direction, replace in sequence as necessary:Laser (REP 7.4), System Controller PWB (REP 9.2).Have the customer send another print job. The print image is properly registered.Y NHave the customer contact the Xerox Customer Support.Problem Solved.A
