02/20006-6 DocuPrint N2125GP 1.2 , GP 1.3Initial IssueGeneral Procedures / InformationGP 1.2 Safety StandardsN2125 satisfies the following safety standards: Table 1GP 1.3 First Print Output Time (FPOT)The First Print Output Time is the time from when the printer receives a START signal in theREADY state, until a single page is printed and delivered into the output tray Table 1.NOTE:1. The data is the theoretical values when the paper is fed from tray 1.2. When Laser Motor OFF, the values are adjusted as follows:• FPOT = t + 4.0 seconds (600 dpi)• FPOT = t + 4.0 seconds (1200 dpi)3. When the paper is fed from other tray, the values are adjusted as follows:• FPOT = t - 1.2 seconds (from MBF)• FPOT = t + 1.2 seconds (from tray 2)• FPOT = t + 2.4 seconds (from tray 3)4. FPOT from the Sleep Mode add up to 65 seconds to each value.Table 1 Safety StandardsCategory Standard SatisfiedLaser Safety 100V/120V type is submitted to FDA 21 CFR (Chapter1, Subchapter J, Section 1010/1040).220V/240V type is submitted to IEC 825 Class 1 laserProduct.Ozone Density Does not exceed 0.02 ppm of ozone density TWA(Time Weight Average), measured according to ECMA129 standardOther standards 100V/120V type satisfies;-UL 1950 3rd Edition, CSA C22.2 no. 950-M95 or equiv-alent, NOM200V/220V satisfies;-IEC 950 including amendments 1,2,3 and 4, CE Direc-tive 1, Nordic and other Agency Approval 2, CCIBNote: 1. When the controller is installed, the OEM cus-tomer shall be responsible for the submittal of CE andCCIB.2. The OEM customer shall be responsible for the Nor-dic agency approvals including NEMKO, SEMKO, SETIand DEMKO.Table 1 FPOTPaperSizeTray 1 (sec) Tray 2 (sec) Tray 3 (sec) MBF (sec)Simplex Duplex Simplex Duplex Simplex Duplex Simplex DuplexLetterSEF9.2 16.517.510.4 17.718.711.6 18.919.99.2 16.517.5A4 SEF 9.3 16.818.610.5 18.019.811.7 19.221.09.3 16.818.6
