Xerox N2125N - DocuPrint B/W Laser Printer Service Manual

Also see for DocuPrint N2125: Product reference guide Specification sheet User guide User guide System administrator guide

Contents

Xerox N2125N - DocuPrint B/W Laser Printer Service Manual Manual pdf 163 page image

02/20004-64 DocuPrint N2125REP 9.11, REP 9.12Initial IssueRepair-AdjustmentREP 9.11 Offset Catch Tray Harness AssemblyParts List on PL 10.1RemovalCAUTIONThese components are susceptible to electrostatic discharge. Observe all ESD procedures toavoid damage.WARNINGSwitch off the power and disconnect the Power Cord.1. Remove Tray 1.2. Remove the Left Interface Cover Assembly (REP 1.1).3. Remove the Left Cover (REP 1.2).4. Remove the Front Cover Assembly (REP 1.6).5. Remove the Left Front Cover (REP 1.7).6. Remove the Top Cover Assembly (REP 1.4).7. Remove the Interlock Cover (REP 1.10).8. Remove the Left Plate Assembly (REP 1.11).9. Remove the Exit Chute Assembly (REP 6.4).10. Disconnect P/J35 from the Print Engine Controller PWB (REP 9.3).11. Release the Offset Catch Tray Harness from all cable clamps (Figure 1).12. Remove the two screws that secure the Offset Catch Tray Harness Assembly (Figure 1).13. Remove the Offset Catch Tray Harness Assembly from the printer (Figure 1).Figure 1 Offset Catch Tray Harness AssemblyReplacement1. Reinstall the components in the reverse order.REP 9.12 Duplex Harness AssemblyParts List on PL 10.1RemovalCAUTIONThese components are susceptible to electrostatic discharge. Observe all ESD procedures toavoid damage.WARNINGSwitch off the power and disconnect the Power Cord.1. Remove Tray 1.2. Remove the Left Interface Cover Assembly (REP 1.1).3. Remove the Left Cover (REP 1.2).4. Remove the Front Cover Assembly (REP 1.6).5. Remove the Left Front Cover (REP 1.7).6. Remove the Top Cover Assembly (REP 1.4).7. Remove the Rear Cover Assembly (REP 1.8).8. Remove the Left Plate Assembly (REP 1.11).9. Remove the Plate Handle (REP 1.12).10. Remove the MBF Chute Assembly (REP 4.1).11. Remove the Paper Handler Assembly (REP 5.1).12. Remove the Transport Chute Assembly (REP 6.1).13. Remove the Fuser Assembly (REP 6.2).14. Remove the Print Cartridge Top Guide Assembly (REP 7.2).15. Remove the Main Motor Assembly (REP 8.1).16. Remove the Drive Gear Assembly (REP 8.2).17. Remove the Print Engine Controller PWB (REP 9.3).18. Remove the LVPS PWB (REP 9.5).19. Remove the two screws that secure the Duplex Harness Assembly to the printer (Figure1).